Wyred-4-sound mINT Manual do Utilizador

mINT Mini-Integrated Owner’s Manual **IMPORTANT** Check position of voltage mains switch prior to connecting the unit to power.

pg. 8 9. Follow all prompts with-in the setup to continue the procedure. (Click “Next” two times) If you are asked to continue with non-Windows “sig

pg. 9 15. 120V/230V Mains Voltage selector switch. Troubleshooting No sound? If you have your input source and speakers connected, and you can

pg. 10 7. Verify that the interconnects are working by replacing them with a different set from a connection that you know works. 8. Now that you hav

pg. 11 Warranty coverage Wyred 4 Sound’s warranty obligations are limited to the terms set forth below: Wyred 4 Sound, as defined below, warrants th

pg. 12 ORAL OR WRITTEN, STATUTORY, EXPRESS OR IMPLIED. AS PERMITTED BY APPLICABLE LAW, WYRED 4 SOUND SPECIFICALLY DISCLAIMS ANY AND ALL STATUTORY OR

pg. 13 Service In the unlikely event there is a problem with your Wyred 4 Sound component, please contact your dealer, distributor, or Wyred 4 Sound

pg. 14

Table of Contents Register Your Product! 1 READ FIRST Important 1 Package Contents 1 Introduction 2 Design and Feature Overvi

pg. 1 Register Your Product! It is very important to complete the warranty registration form located on our website. You MUST complete and submit the

pg. 2 Introduction Thank you for purchasing the Wyred 4 Sound mINT. This compact integrated amplifier is a very versatile unit that will fit well in

pg. 3 Two analog inputs (Auxiliary 1 and 2) are side by side on the rear panel. An alternate function of Aux 2 is HT bypass (Home Theater bypass) and

pg. 4 Getting connected CAUTION: Disconnect the power cord or put the power switch in the “off” position before making any connections to your integ

pg. 5 Front panel operation The mINT is very simple to operate from the remote or front panel. A power button with an illuminated ring light is loca

pg. 6 control. This allows you to use the volume of your processor to adjust the level of your whole system. This is a configuration switch and must

pg. 7 2. The USB device should automatically start installing. 3. It is now necessary to select the mINT as the output device. Please locate the